I have a firestorm 10t, I put 3 clutches in it since last July. The spring in the clutch assembly keeps breaking. Is there anything I could do to prevent this issue from occurring? …

I have a setup of a Proton 3S, an Arrowind 12A and a Futaba R607FS and after a small accident it stopped working. I get a beeping pattern that I don't understand, does anybody know …

What's the difference between a two and a three blade propeller? or any other amount of blades for that matter.

Li-Po or LiPo? Which way of writing it do you like best?

How thick should EPP be to build airplanes?

Hello, Is the aileron in this Extra 300S moving enough for doing 3D? http://vimeo.com/13656139 (And what's the proper way to say it in English? "Does it have enough throw?")

Any ideas how to get the GH MicroJet V3 in Europe? Specifically in Zürich, Switzerland. I went to a couple of hobby shops and none have it. If not, how do I find an equivalent?

What density of EPP should I use for a model plane? Any ideas how much is used for something like this: http://www.rcpowers.com/airplanes/grayson-sukhoi.htm

I have just broken the supplied prop on my Multiplex Easy Cub. The prop is marked APC 10x5 and 254x127, the metric size and C-2 on the back of the hub. I wish to replace it but can …

How do I charge a NiMH battery? Let's build a comprehensive answer that people can point to that will allow anyone to charge a NiMH in any mode and with any charger. Let's be prac …

Are there any other differences between the iCharger 106B+ and the iCharger 1010B+ other than: the maximum power/current and the amounts of LiPo cells they can charge?

My Firestrorm 10T has a idle screw in a difficult position. You can't get to it with a screw driver because the gear box is only about 1/4" right in front of it. I was wondering if …

When do you balance LiPo batteries? Do you balance every N charges? If so, how many charges? Do you measure them and balance them when they are drifting too much appart? If so, how …

A four-channel receiver has outputs typically labelled RUDD, ELEV, AILE, and THRO. What are the format of these outputs (e.g. analog voltage)? Do all receivers use the same stand …

Are there any RC bloggers that you follow on a regular basis?